Olec OLITE - Page 43

94MS20 Rev. B4 5-17
LT8 lampheads
• Remove the four hex nuts mounting the blowers, disconnect the blower
and thermostat wires.
End
View
• Remove the four screws holding the rear reflector to the cooling tubes
and remove the reflector and lamp from the lamp head.
!
C DO NOT TOUCH THE REFLECTOR SURFACE WITH
YOUR HANDS.
Bottom
View
• Remove the three screws from the blower mounting plate to the cooling
tubes on both sides. Compress the cooling tubes into the shutter assembly,
remove the chain from the motor sprocket, then remove the shutter
assembly.
End
View
• Reassemble in reverse order.
!
C DO NOT TOUCH THE REFLECTOR SURFACE WITH
YOUR HANDS.