Olympus BH2 Series - Page 85

15-1-8 Put two Wire Guides AB018900on Lateral
Arm
Guide AW018700 and assemble them tern-
porarily by using four Screws AB3x6SH.
(See Fig. 15-41
15-1 -9 Pressing down Lateral Guide AB018700
with two fingers, retighten four Screws
AB3x6SH. Check the movements of Lateral
Guide according to steps in NOTE below:
Fig. 154
P--- - -
Arljustment knob
NOTES:
1. The feed Plate must move smoothly with-
out friction or play.
2. The Feed Plate must move lightly.
3. The casing must be centered with the Wire
Guide.
b
15-1-10 Apply Adhesive OT1028 at three or four
points on Lateral Guide At3018700 and
Upper Stage. (See Fig. 75-51
a) Apply Shellac OT1131 to four Screws
AB3xGSH to prevent them from loosening.
(See Fig. 75-51
Fig. 15-5