Olympus BH2 Series - Overall Check

Fig. 11 -1 8
1 1-5-2
Adjust left side tube length:
a) After focusing on the right side, put KN-
0022 and C-15 into the left side sleeve.
b) Taking tube length on the right side as
standard, turn Diopter Ring AB032700 in
either direction to bring the specimen into
focus.
c) Loosen Set screw ACU2.6x4SA on Diopter
Ring
AB032700. Turn the Diopter Ring
only until the index of the Finger Rest
L
indicates 0 on the Diopter Ring. Then fix
tlie Diopter Ring by tightening Set screw
ACU2.6x4SA.
1 1 6 I
I)rvi,~tio~l ol parcentration for right and left
0111 lC,3I ,lACS
:; 1 AN I)AIj I1 (i~~i;i(je fortnation plane of ob-
/c(:t IV~!) : 0.2
#I) 11:;~ ill(! follow~~~g Jigs on 1 tic Microscope
Sland:
Cotilcririg ol~jcctivc: KN0005
1 Ox eyepiccc with cross hair: C-1
1)) Place C-1 in the right and left eyepiece
sleeve and make sure that the cross hair
of
C-1 is within 3 divisions of the center
cross hair of
KN0005.
(See Fig. 11 -1 8)
c) If this STANDARD is not met, repeat the
adjustment in step 1 1-2 above.
d) When the right and left optical axes are
within
3 divisions of the center cross hair
of
KN0005, take the one nearer the center
cross hair as standard and adjust the other
within 2 divisions on
KN0005.