Olympus BH2 Series - Assembly Procedures; Fine & Coarse Adjustment Unit Assembly

4. ASSEMBLY PROCEDURE FOR FINE & COARSE ADJUSTMENT UNIT OF BHS
4-1 Assembly of Coarse & Fine Adjustment Guide
AB024 JOO Unit.
4-1 -1
Assemble Guide Fixing Piece ABO09700 with
lnner Ball Guide ABO24700 by tightening
two Screws AB3xl6SA. (See Fig. 4-3.)
NOTE:
The Screws should be tightened temporarily
to such a degree that they will not drop from
AB3x 1 6SA
the Gu ide Fixing Piece.
AB009700
Fig. 4-1
Assemble Rack AB024100 wi.th lnner Ball
Guide AB024700.
For this purpose, attach positioning Jig
B2KC1006 to l nner Ball Guide AB024700 as
shown in Fig. 4-2, press Rack AB024100
from the right side to the Jig and fix it by
tightening two Screws AB3x8SA.
(See Fig. 4-2.1
'~80243 00
Fig. 4-2
4-1-3 Assemble four Wire Guides AB023500 into
the guide groove of Arm AB022900.
NOTE:
After applying Grease OT2008 onto each
surface of the Wire Guides, strech and clamp
them into the guide groove. {All the wire
guides should be coated with Grease and set
in this manner.)
{See Fig. 4-3.)
I
A8023500
CAUTION:
4
Make sure that the Wire Guides are not bent,
scratched or nicked, which may cause
malfunction.
Fig. 4-3