Olympus BH2 Series - Assembly Procedure for BH2-AAC

18. ASSEMBLY PROCEDURE FOR B1-12-AAC
I
3 8-1 Assemble Front Lens ZA078100 with Condenser
Body A6040200 as follows:
(See Fig. 18-71
18-1-1 Apply Adhesive OT1028 to Front Lens
OT1028 ZA078100 and put in Condenser Body
ABO4Q200.
-ZAO78100
a) Apply the Adhesiv~ to the entire cir-
cumference since it scrvos also as sealing
between the Coridt!nsor Body and Lens.
b) Wipe off excessive Adhesive.
18-1-2 Place the Condenser Body upside down and
let it dry for 24 hotlrq,
Fig. 18-7
18-2 Assemble Lens l,A4"s 100 iri position,
Tighten Retairwr Al304O5(10 IIV using Adjustable
Spanner OT0072.
(See Fig. 77-31
18-3 Put Lens ZAO780(10 Irr (ru!;ltlon,
(Soc Fig. 17-3)
18-4 Put Spoccr All1140400 In ~rnci lion.
(See Fig, 17-3)
18-5 Put Lcns ZAO77!SO0 Iri ~rnslt Ion.
ISco Fig, T 7-3)
18-6 Assemt)ln Rr?t~~i~l~r Annrlfl5Ofl in position by
usinfl A~lj~~ti~t~l~ Sllnr~rlrv t 1'1 nr)??.
(Scc Fig, 1 7-3)
18-7 Ass~mlllrl r!irtlit. Diaphriiqm Hlntl~s %A078700 in
position.
NOTE:
For assernhly, the Blades should be placed in the
cage in o clockwise sequence, as shown in I
Fig. 18-7, I I
Fig. 18-2