Olympus BH2 Series - Disassemble Coarse Adjustment Guide

-
3-5 Disassemble Coarse Adjustment Guide as follows:
3-5-1
Detach Cover AB024900 from the front side
of Arm by removing four Screws P U K2x4SA.
p-r PU K2x4bu
(See Fig. 3-79,)
AB024900 --
Fig. 3-19
.- 3-5-2 Detach the Arm from the Base by removing
four Screws AB6x25SA.
(See Fig, 3-20.)
NOTE:
For removing the Screws, place the Micro-
scope
Stand on its side. In this case, however,
take care not to drop the Arm since it has no
Knock Pin fitted into the base.
Fig, 3-20
1
- TT 7 F- 3-5-3 After placing the Arm on its side, dismount
Rack AB024100 by removing two Screws
AB3xBSA. (See Fig. 3-21 .)
rl
L
ie
Lc5ESY
Fig. 3-21
1