Olympus BH2 Series - Assemble the Condenser Holder Unit; Assembly Procedure for BH2-CH

Fig. 7-7
% 7-2-6 Remove Screw AA253000.
* 7-2-7 Remove Spring AA097400.
7-2-8 RemoveShaftAB026200. (See Fig. 7-7.)
NOTE:
The Spring and Shaft can ba rlismotr nted after
Screw AA253000 is removed.
CAUTION
:
Do not remove Height Adjustment Pin NP5x
12WO. (Scc Fig. 7-7.)
7-2-9
After disassembly, Wash tlir: parts with xylol
or gasoline to rernovt! qreasc?. Thcn, wipe off
xyloi or gasoline cornplotcly with a piece of
drv cloth.
8. ASSEMBLY PROCEDURE FOR BH2-CH
8-1 Assemble the Condnnsnr Hnlder Unit as per the
procedure below:
Fig. 8-1
After appl yinq G rcnse OT2008, assemble
Shaft AB026300 In pasi tian.
(See Fig. 8-1 .)
After ilpplyinrl Grcasr: OT2008, assemble
Spring
AB076300 in position. {See Fig. 8-1 .)
Tighten Scr~w AA3530OO in position.
(See Fig, 8-1.)
After applyirlq Grease OT2008 to the slide
surface, assemble Condenser Mount AB-
059500 in position. (See Fig. 7-5.)
8-1 -5
Attach thrc!e Plates A6061400 by tightening
six Scrcws 3PUK3x4SA. (See Fig. 7-4.)
8-1-6 Aftcr applying a small amount of Grease
OT2006 to the thread, assemble Centering
Knoh AB026000 in position. (See Fig. 7-4.)
8.1-7 Aftet applying a small amount of Grease
OT7006 to the thread, assemble Clamping
Knob AR059600 in position. (See Fig. 7-4,)
8-1 -8
Check operation by manipulating the Center-
ing Knob.
8-1-9 Assemble Rack AB026700 in position by
tightening two Screws CU K2.6x6SA.
{See Fig. 7-6.)