Olympus BH2 Series - Assemble the Stage Mount Unit

8-2 Assemble the Stage Mount Unit as follows:
AB 026400 8-2-1 With Washers AA272600, NW4.6-26580 and
Balls 83/32 placed on Pinion AB026800,
assemble it in Stage Mount Unit AB026400.
NOT€
Apply Grease OT2008 to the parts indicated
by arrows. (See Fig. 8-2.)
8-2-2
Asscrnbic? Tcr~sion Scr~w A0026900 in posi-
tion.
8-3.3
Assernl>lr! Nut AA007700 in pas1 tion by using
Tool K KAA0077,
Fig. 8-2
!I-2-4 Assemhl~ I(nat~ AB059800 in position. For
/- AA 272800
this purpose, fit the Pinion Shaft into the
NW 4.6-3858n tit~le lormarl in the Knob and tighten two
Screws ACU3x4SA firmly.
(See Fig. 8-2.)
8.2-5
Check Pinion for its operation and adjust it if
required.
s y-'
a) When the Pinion rotates too lightly or
has thrust play:
Loosen AA007700.
4
Tighten A8026900.
4
Tighten AA007700.
b) When the Pinion rotates too heavily:
Loosen AA007700.
-1
Loosen ABQ26900.
5.
Tighten AA007700.