Olympus BH2 Series - Vertical Ball Guide Unit Assembly; Vertical Control Knob Unit Assembly

15.3 Assemble the Vertical Control Knob unit as per
Il~r! following:
15 3 1
Asst!rnhle ttre Knob Mr~rrnt:
:I) Apply Grcnsrr OT3008 to each sliding
%ti r face.
OT2008
I,) Ansnmhln Wnshrlr An031 000 with Pinion
AI~~~70~1~~.
c] T~WT!~{~I ~brily r!fiw~~bldfj Nt~t NN4SA.
(Sen Fig. 15-1 1)
Fig. 15-1 1
Fig. 15-12
15-3-2 Assemble the Knob Mount assembly with
the stage:
a) Apply a small amount of Adhesive OT-
I127 to Screws AB3x8SA and tighten it.
b) Position the Knob Mount assembly so
as to be parallel with the side of the
stage. (See Fig. 15-1 2)
15-3-3 Temporarily assemble Lateral Rack AB-
079300 by using two Screws CUK3x8SA.
(See Fig. 15-1 2)
NOTE:
The Lateral Rack must operete smooth with
no thrust play.
15-3-4 Finally Tighten Nut NN4SA by usinq Tool
K K6450.
NOTE:
The l~t~r~l rnck milst opnrntfl smoothly
with no Pntornl plny.