Olympus BH2 Series - Page 33

4-1-4 Assemble Spacer AB023300 and Rollers
AB022700 (lower side only).
NOTES:
.. .-
1. Apply a thin layers of Grease QT2008 to
----
the Rollers and Spacer respectively.
id- - - , 5-2 :<g '
2, Arrange the Rollers in alternate directions
as shown in Fig. 4-4 and place the Spacer
at the center, (See Fig. 4-4.)
Fig. 4-4
4-1-5 Assemble Wire guides A8023400 with the
Inner Ball Guide.
NOTE:
The Wires should be assembled by the same
procedure as that for assembling them with
the
Arm. (See Fig. 4-5.)
Fig. 4-5
p-- - 1
4-1-6 Mount two Wire Guides ABQ23400, eight
Rollers AB022700 and Spacer A6023300 on
Ball Guide A6024800. (See Fig. 4-6.)
AB02330Q
NOTE:
Assembling procedure is the same as that
for assembly with the Arm.
Fig. 46