88
6
Playback
Adding sound to still pictures
Sound can be added to a still picture that you have already taken. You can
also re-record over the sound that has already been recorded. Total
recording time per picture is approximately 4 seconds.
Select the still picture to which you want to add sound and display the top
menu.
Top menu [MODE MENU] [PLAY] [R ] g“Using the menus” (P. 17)
1 Press q to display [START].
2 Aim the camera microphone
toward the sound you want to
record, and press Z to start
recording.
• The [BUSY] bar is displayed during
recording.
Note
• If the microphone is farther than 1 m (3.3 ft.) from the subject, sound may not
be recorded properly.
• If you re-record the sound, the original sound is erased.
• Sound recording is not possible if there is insufficient space in the internal
memory or on the card.
• The microphone may pick up the sound of buttons operated.
• Once sound is added to a picture, it is not possible to erase the sound. In this
case, make a re-recording with silence.
PLAY
EDIT
MEM
SET
START
Microphone
To Next Page
Loading...
Need help?
General
