Using an external flash [Remote Flash] Point the remote [_ Flash direction
....... B_Qt'_ E!ash :ens°'rat°Wardthe
N I @@
_ The external flash is not available.
An Olympus WirelessRC Flash
- System compatible flash is used
,'I RC for taking pictures. (Channel: CH1,
Group: A)
The commercially-available slave
flash that is synchronized with the
Slave camera flash is used for taking
pictures. The flash intensity setting
can be adjusted.
Taking pictures with the Olympus
Wireless RC Flash System .........................................................................................
You can take pictures with a wireless flash when using
a flash compatible with the Olympus Wireless RC Flash
System. This enables multi-flash photography using
multiple flash units compatible with this system. The
camera's built-in flash is used for communication between
the camera and flash.
_} For details about operation of a wireless flash, refer
to the instruction manual for the special external
flash.
Set the wireless flash based on the guidelines
below.
Wireless flash setup range guidelines
_ The setup range varies depending on the ambient
environment.
2
3
4
5
®
6
®
Turn on the wireless flash.
Use the MODE button on the wireless flash to
set to RC mode, and make the channel and
group settings. (Channel: CHf, Group: A)
Set [Remote Flash] (p. 44) on the camera
to [_RC], and set the channel to the same
setting as the wireless flash.
Select the flash mode.
"Using the flash" (p. 35)
Take a test shot to check the operation of the
flash and the resulting image.
Be sure to check the charge level of the camera and
wireless flash before taking pictures.
Although there is no limit on the number of wireless
flash units that are set up, usage of a maximum of
three units is recommended to prevent malfunction
due to interference with each other.
When the camera flash is set to [_. RC], the camera
built-in flash is used for communication with the
wireless flash. It cannot used for taking pictures.
EN