Adjusting the CCD and the image Adjusting the brightness of the monitor
processing function [Pixel Mapping] [I..C_,l]
........t'$2 (Settings 2) _ Pixe! Mapping 2) _ !,_ ...................................................................................................
@}} This function has already been adjusted at factory
shipping, and no adjustment is needed right To adjust the monitor brightness
after purchase. Approximately once a year is q" Use /kV to adjust the brightness while viewing the
recommended, screen, and then press the _) button.
(_j_} For best results, wait at least one minute after taking
or viewing pictures before performing pixel mapping.
If the camera is turned off during pixel mapping, be
sure to perform it again.
To adjust the CCD and the image
processing function
Press the (_ button when [Start] (Submenu 2) is
displayed.
• The camera checks and adjusts the CCD and the
image processing function at the same time.
Playing back images on a TV [TV Out]
......f'l'2 (Settings 2)_ I_Out ............
_ TheTVvideosignalsystemvariesdependingon thecountriesandregions.Beforeviewingcameraimageson your
TV,selectthe videooutputaccordingto your TV'svideosignaltype.
NTSC Connecting the camera to a TV in North America, Taiwan, Korea, Japan,
and so on.
PAL Connecting the camera to a TV in European countries, China, and so on.
480p/576p
HDMI Out 720p Set the playback format.
Off Operate with the camera.
HDMI Control
On Operate with the TV remote control.
_f_ The factory default settings differ according to the region where the camera is sold.
EN
To Next Page
Loading...
Need help?
General
