10-019116-01EN, Rev. 2, January 2021
Maintenance and Troubleshooting 51
4.1.2 Measurement Window Removal
This procedure requires that you unlatch the measurement window faceplate from
the Vanta iX probe.
To unlatch the measurement window faceplate
1. Turn off the Vanta iX.
Olympus recommends that you remove the network cable before removing the
measurement window to be sure that the Vanta iX cannot be remotely started.
2. Locate the window faceplate latch at the front of the instrument (Figure 4-1 on
page 51).
Figure 4-1 Window faceplate latch
To Next Page
Loading...
