Olympus Vanta iX Series - List of Figures

10-019116-01EN, Rev. 2, January 2021
List of Figures 73
List of Figures
Figure i-1 Rating label location ............................................................................................ 1
Figure i-2 Radiation label locations ..................................................................................... 2
Figure 1-1 Dosimeters — Various styles ........................................................................... 26
Figure 3-1 I/O panel connectors ......................................................................................... 36
Figure 3-2 DC power cable .................................................................................................. 36
Figure 3-3 Ethernet (PoE+) cable ........................................................................................ 37
Figure 3-4 USB data cable .................................................................................................... 38
Figure 3-5 Radiation LED assembly .................................................................................. 38
Figure 3-6 CUST I/O cable ................................................................................................... 39
Figure 3-7 OLY I/O cable ..................................................................................................... 40
Figure 3-8 GPIO board ......................................................................................................... 41
Figure 3-9 Vanta iX left side ................................................................................................ 43
Figure 3-10 Vanta iX right side ............................................................................................. 44
Figure 3-11 Vanta iX top ........................................................................................................ 45
Figure 3-12 Vanta iX bottom ................................................................................................. 46
Figure 3-13 Vanta iX front ..................................................................................................... 47
Figure 4-1 Window faceplate latch .................................................................................... 51
Figure 4-2 Latch pulled out ................................................................................................. 52
Figure 4-3 Faceplate latch fully open ................................................................................. 52
Figure 4-4 Faceplate alignment tab fully visible .............................................................. 53
Figure 4-5 Measurement window on faceplate ................................................................ 53
Figure 4-6 Peeling the window (left) and pulling it off (right) ...................................... 54
Figure 4-7 Peeling the window from its backing ............................................................. 54
Figure 4-8 New window aligned with faceplate .............................................................. 55
Figure 4-9 Orienting faceplate with latch and probe cutout .......................................... 56
Figure 4-10 Inserting alignment tab into tab slot ............................................................... 56
Figure 4-11 Latch over faceplate catch ................................................................................ 57
Figure B-1 Test setup and survey diagram ........................................................................ 63