11.3 Working with cursors and the cursor table
The Bode Analyzer Suite offers cursors (markers) to read the exact value of a trace at a specific
frequency. In the following, a short overview on the functionality of cursors is given.
11.3.1 The cursor table
The cursor grid respectively cursor table shows the values of normal value-cursors and delta-cursors.
A delta-cursor can be configured to show the difference between two cursors whereas a normal value-
cursor shows the value of a trace at a specific frequency.
The cursor table offers the following interactive functions:
• Switch cursors on and off by clicking on the checkbox besides the cursor name .
• Delete a cursor by clicking on the recycle-bin icon in the last column. Note that a cursor cannot
be deleted if it is used by some other function such as a delta-cursor. Then the recycle-bin icon is
greyed out.
• Move the cursor up or down in the cursor table by clicking on the dotted area left to the checkbox
and drag it to the desired position holding the mouse clicked.
• Set the cursor frequency by clicking into the frequency field and manually entering a frequency
.
• Move the cursor to a specific measurement result by entering the desired value in the Trace
column .
• You can also enter a delta value and the second cursor will try to find a frequency where the delta
value can be achieved.
If an entered value cannot be found, the following information is shown.
.
Bode Analyzer Suite software features
OMICRON Lab
125
To Next Page
Loading...
