9 Measurement and Device settings
This chapter focuses on settings and options that are required to perform good measurements. Details
such as configuring the right attenuator or the correct signal source level are discussed in the
following.
9.1
Hardware setup
By clicking on the Hardware setup icon , the hardware setup dialog is opened.
The hardware setup dialog shows the internal connections of Bode 100 as well as the external
connection to the DUT. Depending on the selected measurement mode, hardware settings such as
Channel termination, Receiver connection or an external Probe factor can be changed.
Figure 9-1: Hardware setup dialog in Gain/Phase measurement mode.
74
OMICRON Lab
To Next Page
Loading...
