Radius and Decimal point
Please consider:
• The angle unit is always radian
• The radix character is always a decimal point. For
example 2.5 equals two and a half.
Expression field
The expression is entered in the expression field.
Operands and operators can be selected from the
ribbon elements or directly entered in the expression
field.
A Search function will show the available elements
during typing.
Apply & Close
After an expression has been successfully parsed
, the expression can be applied using one of
the two buttons at the lower right-hand corner:
• Apply will calculate the results values without closing the editor window.
• Apply & Close will calculate the result values & close the editor window.
In both cases the resulting expression curve is shown in the corresponding chart in the Bode Analyzer
Suite main window.
Expression trace configuration
The Expression trace and its chart view can be configured using the trace configuration box. The
Expression trace, has the following specific options:
The expression entered in the editor is shown in the
Expression field.
The result of an Expression trace can be
copied to a Memory trace using the button
.
The editor window can be opened again by clicking the pen
icon or by clicking into the expression field.
If the frequency points of the used operands differ, an info
icon will be shown in the trace header
. Either linear
interpolation will be used to find the needed operand values
or the values will be skipped.
140
OMICRON Lab
To Next Page
Loading...
