The Main window is structured into six main regions:
1. Measurement configuration
The measurement configuration allows to configure the measurement frequencies and some
hardware setup elements such as the source level, the attenuators and the receiver bandwidth.
2. Chart region
In the chart region the measurement results are displayed. You can use the Trace settings on the
right hand side to choose the result that shall be displayed. Different formats such as Magnitude or
Phase as well as different diagrams such as Polar, Nyquist or Smith can be selected. To learn
more about the result diagrams, have a look at 11.2 Using the interactive chart on page 117.
3. Trace settings
Choose what measurement and which result format is displayed in a trace. Additional memory
traces or math traces are also controlled in this region. Lear more about how to configure traces
and memories in 11.4 Using the memory traces on page 130 and 11.5 Working with measurement
and math traces on page 134.
4. Ribbon bar & Quick-Access
The ribbon bar contains the file operation commands as well as the buttons to start and stop a
measurement. Further possibilities are the hardware setup, calibration, view settings, memory
operations and cursor commands.
5. Cursor table
The cursor table displays the values of the movable cursors that are attached to the traces shown
in the result diagrams. To learn more about how to use the cursors, check out 11.3 Working with
cursors and the cursor table on page 125.
6. Status bar
The status bar shows the connection state of the hardware and the receiver levels. Further
possibilities are signal source control and internal device calibration control.
Bode Analyzer Suite introduction
OMICRON Lab
21
To Next Page
Loading...
