Omicron Lab Bode 100 - Page 4

8.3.3 Reflection with external coupler .........................................................................................................
51
8.4 Impedance analysis ........................................................................................................... 52
8.4.1 One-Port ............................................................................................................................................
52
8.4.2 Impedance Adapter ............................................................................................................................
61
8.4.3 Shunt-Thru .........................................................................................................................................
66
8.4.4 Shunt-Thru with series resistance .....................................................................................................
68
8.4.5 Series-Thru ........................................................................................................................................
69
8.4.6 Voltage/Current ..................................................................................................................................
70
8.4.7 External Bridge ..................................................................................................................................
71
8.5 Advanced .......................................................................................................................... 72
8.5.1 SCPI server ........................................................................................................................................
72
9 Measurement and Device settings ................................................................................. 74
9.1 Hardware setup .................................................................................................................. 74
9.2 Receiver Bandwidth ........................................................................................................... 76
9.3 Choosing the receiver attenuator ....................................................................................... 78
9.4 Signal source settings ........................................................................................................ 80
9.5 Using external probes ........................................................................................................ 83
10 Calibration / Correction ................................................................................................... 85
10.1 Internal device calibration ................................................................................................... 85
10.2 Performing a Gain Calibration ............................................................................................ 86
10.2.1 Calibrating a Transmission (S21) measurement ................................................................................
88
10.2.2 Calibrating a Gain/Phase measurement ............................................................................................
89
10.3 Performing an Impedance Calibration ............................................................................... 91
10.3.1 Calibrating a Reflection or One-Port Impedance measurement ........................................................
94
10.3.2 Calibrating an External Coupler or External Bridge measurement ....................................................
96
10.3.3 Calibrating an Impedance Adapter measurement .............................................................................
98
10.3.4 Calibrating a Shunt-Thru or Series-Thru measurement .....................................................................
100
10.3.5 Calibrating a Voltage/Current measurement ......................................................................................
102
10.4 Further calibration information ...........................................................................................103
10.4.1 Difference between Full-Range and User-Range calibration .............................................................
103
10.4.2 Enabling and disabling a calibration ..................................................................................................
105
10.4.3 Re-performing a calibration ................................................................................................................
106
10.4.4 Full-Range calibration below 10 Hz ...................................................................................................
106
10.4.5 Automatic deletion of calibration ........................................................................................................
107
10.4.6 Saving calibration data .......................................................................................................................
107
10.4.7 Exporting calibration data ..................................................................................................................
108
11 Bode Analyzer Suite software features ..........................................................................109
11.1 Exporting and saving measurement data or settings ......................................................... 109
11.1.1 Loading and saving the equipment configuration .............................................................................
109
11.1.2 Use the clipboard functions to export data .........................................................................................
109
11.1.3 Use the clipboard to import data ........................................................................................................
111
11.1.4 Exporting measurement data to CSV or Excel files ...........................................................................
113
4
OMICRON Lab