Omicron Lab CT SB2 - 4 Running a CT Test (Detailed)

47
Short Guide for Running a CT Test
Test execution:
Burden test
Test finished message
-> 4.3, step 11. on page 54
Disconnect or perform new test
-> 4.5 on page 57
Burden test card
enabled?
Connect CT Analyzer
for burden test
-> 2.4.2 on page 26
Start Test
soft key
Skip Test
soft key
Cancel Test
soft key
Connect CT Analyzer
for CT test
-> 2.4.1 on page 24
Prim.
Winding Resistance
measurement
enabled?
Connect CT Analyzer for
primary winding resistance
measurement
-> 2.4.3 on page 27
Start Test
soft key
Skip Test
soft key
Cancel Test
soft key
View results
-> 4.4 on page 55
Start Test
soft key
Skip Test
soft key
Cancel Test
soft key
Test execution:
CT test
from previous page
Yes
No
Yes
No
Test execution:
Prim. winding resistance
measurement
Residual Magnetism
measurement if enabled
-> 6.4 on page 102