CT Analyzer User Manual
82
6.2.3 Parameters and Settings Used or Determined by the Test
Process
The fields described in this section are used and/or determined by the test
process.
Figure 6-3 Editing the CT-Object card
Note: If the "Check "*" settings before start" option is enabled in the default test
settings (see section 5.7.3 ”Miscellaneous Settings” on page 70), no automatic
assessment will be available if you do not enter data for a parameter that is
relevant for assessment. Such parameters are marked by a star "*" in the
CT Analyzer user interface and in the following tables.
To Next Page
Loading...
