Omicron Lab CT SB2 - New CT-Test; New MR-Test; New Quick-Test

61
Operating and Configuring the CT Analyzer
5.3 New CT-Test
By selecting "New CT-Test" in the main menu and then pressing the OK soft
key, a new CT test with the default parameter settings is loaded and displayed
in the CT-Object card. Some of the default values can be defined in the default
test settings (see section 5.7 on page 65).
Figure 5-5 CT-Object card with default test settings after initializing a new
CT test
Note: For more detailed information about the parameters and fields in the
CT-Object card, please refer to section 6.2 on page 80.
5.4 New MR-Test
Using the "New MR-Test" option in the main menu you can initialize a new multi-
ratio CT test using the optional CT SB2 switch box.
This option is only available if you have purchased a corresponding license. For
more detailed information about multi-ratio CT testing using the CT SB2, please
refer to the CT SB2 User Manual.
5.5 New Quick-Test
Using the "New Quick-Test" option in the main menu you can open the optional
QuickTest feature. With this feature you can use the CT Analyzer as a
multimeter or perform polarity checks using the CPOL polarity checker.
This option is only available if you have purchased a corresponding license. For
more detailed information about QuickTest, please refer to chapter 8 on
page 135.
Press the Main soft key in
any test card
Main Menu:
- New CT-Test
OK soft key
-> CT-Object card
How to get there:
Press the Main soft key in
any test card
Main Menu:
- New MR-Test
OK soft key
-> CT-Object card
How to get there:
Press the Main soft key in
any test card
Main Menu:
- New Quick-Test
OK soft key
-> CT-Quick card
How to get there: