Omron NX-SID Series User Manual

Data Type
BOOL
BYTE
INT
WORD
DINT
l
Analog I/O Units
The table below shows the NX Unit models that support communications between the NX Units as
well as the combinations of the Unit version and Sysmac Studio version.
Model Unit version Sysmac Studio
NX-AD2203 Ver. 1.0 Ver. 1.10 or higher
NX-AD2204 Ver. 1.0 Ver. 1.10 or higher
NX-AD2208 Ver. 1.0 Ver. 1.10 or higher
NX-AD2603 Ver. 1.0 Ver. 1.10 or higher
NX-AD2604 Ver. 1.0 Ver. 1.10 or higher
NX-AD2608 Ver. 1.0 Ver. 1.10 or higher
NX-AD3203 Ver. 1.0 Ver. 1.10 or higher
NX-AD3204 Ver. 1.0 Ver. 1.10 or higher
NX-AD3208 Ver. 1.0 Ver. 1.10 or higher
NX-AD3603 Ver. 1.0 Ver. 1.10 or higher
NX-AD3604 Ver. 1.0 Ver. 1.10 or higher
NX-AD3608 Ver. 1.0 Ver. 1.10 or higher
NX-AD4203 Ver. 1.0 Ver. 1.10 or higher
NX-AD4204 Ver. 1.0 Ver. 1.10 or higher
NX-AD4208 Ver. 1.0 Ver. 1.10 or higher
NX-AD4603 Ver. 1.0 Ver. 1.10 or higher
NX-AD4604 Ver. 1.0 Ver. 1.10 or higher
NX-AD4608 Ver. 1.0 Ver. 1.10 or higher
NX-DA2203 Ver. 1.0 Ver. 1.10 or higher
NX-DA2205 Ver. 1.0 Ver. 1.10 or higher
NX-DA2603 Ver. 1.0 Ver. 1.10 or higher
NX-DA2605 Ver. 1.0 Ver. 1.10 or higher
NX-DA3203 Ver. 1.0 Ver. 1.10 or higher
NX-DA3205 Ver. 1.0 Ver. 1.10 or higher
NX-DA3603 Ver. 1.0 Ver. 1.10 or higher
NX-DA3605 Ver. 1.0 Ver. 1.10 or higher
The data types in the following table are supported for communications between NX Units.
Data Type
BOOL
BYTE
INT
WORD
DINT
Appendices
A - 108
NX-series Safety Control Unit User's Manual (Z930)

Omron NX-SID Series Specifications

General

Brand	Omron
Model	NX-SID Series
Category	Controller
Language	English