Omron NX1P2 series

I - 4
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)
Index
Supply from external source ......................................... 4-10
supply from the NX bus ................................................ 4-10
Support Software ..................................................... 1-5, 1-7
Sysmac Studio .............................................................. 3-33
System Initialization Error ............................................... 6-3
System-defined variables ............................................. 6-10
T
Terminal hole ................................................................ 3-10
Troubleshooter ............................................................. 6-10
Troubleshooting Function ............................................... 6-9
twisted wires ................................................................. 5-48
U
Unit hookup guide .......................................................... 3-5
Unit power supply .................................................. 4-3, 4-18
Unit Version ...........................................................3-18, A-6
User Program/Controller Configurations and Setup
Transfer Error ............................................................ 6-62
V
voltage drop in the I/O power supply ................... 4-11, 4-15
W
Wiring Duct ................................................................... 5-12
Wiring the Unit Power Supply ....................................... 5-39
Write Protection Key ..................................................... 3-19