Omron R88D-1SAN-ECT Series -  Mounting the Servo Drive

20
◼ Mounting the Servo Drive
1.
Put the Servo Drive in place and secure the top first and then the bottom.
Temporarily tighten the screw to attach the lower part of the Servo Drive and slide the
Servo Drive from top to bottom to put the U-groove of the Servo Drive on the screw.
2.
Tighten the screw at the upper part.
3.
Tighten the screw at the lower part.
4.
Mount a shield clamp bracket to the Servo Drive.