105
Read Controller Status Section 6-6
(3) Response Codes
Response
code
Error name Cause Error
priority
1001 Command too long The command is too long. 2
0000 Normal completion No error 0
Next, 2 bytes for each of the 8 branch outputs
0: Event did not occur.; 1: Event occurred.
Hardware cutoff (subject to cutoff)
Abnormal current trip (cutoff by software: subject to cutoff)
Not used (0)
Not used (0)
Overcurrent alarm
Not used (0)
Not used (0)
Cutoff by HMI or communications (subject to cutoff)
To Next Page
Loading...
