14
S8AS Operating Procedure Section 1-4
Monitor temperature
rise in control panel
and prevent over-
heating.
In Setting Mode, set the over-temperature output
threshold (TMP). Take the signal from the Over-
temperature Output (TMP) terminal and use that
signal to operate a fan or air conditioner.
p. 35,
p. 65
p. 50
Restrict read/write
access of parame-
ters to prevent mis-
taken operations.
Select the protection level setting (PRT) from the
Mode Selection Menu and set the desired pro-
tection level.
p. 54,
p. 59
Desired objective/
usage
Settings Details
To Next Page
Loading...
