58
Switching the Operating Mode Section 4-2
Note The procedure for initializing parameters is given below. (Parameters cannot
be initialized for the S8AS-24006N/48008N.)
After the parameters have been initialized, the default settings will be in effect
and the initial power-ON status will be used.
• The operating mode will be Run Mode.
• All branch outputs will be connected.
• Protection level 1 will be used.
Press the Key from the initialize display (INI). The S8AS will switch
to the parameter initialization display.
If the Key is pressed, NO will be displayed. Initialization cannot be
performed from this display.
(The S8AS will automatically return to the Parameter Initialization Dis-
play (INI) if no key is pressed within 3 s.)
Press the Key. The display will change to YES. The parameters will
be initialized if the Key is pressed from this display.
(The S8AS will automatically return to the Parameter Initialization Dis-
play (INI) if no key is pressed within 3 s.)
Press the Key to start initializing parameters.
INI will flash on the display while parameters are being initialized. When
the display stops flashing, all parameters will have been initialized.
The operating mode will change to Run Mode.
i n i
1
2
3
4
5
6
V
A
Yrs
s
°C
n o
1
2
3
4
5
6
V
A
Yrs
s
°C
()
y e s
1
2
3
4
5
6
V
A
Yrs
s
°C
Flashing
i n i
i n i
1
2
3
4
5
6
V
A
Yrs
s
°C
2 4. 0
1
2
3
4
5
6
V
A
Yrs
s
°C
To Next Page
Loading...
Need help?
General
