Omron SJDE-ANA-OY - CX-Drive Usage

114
3. Set and confirm the SERVOPACK station
address.
• Use SW1 and bit 3 of SW2 to set the station address
(axis address). Refer to 3.8.3 Setting Communica-
tions Specifications. When using the factory setting,
check the setting as well.
4. Turn ON the SERVOPACK power supply.
• Turn ON the SERVOPACK power supply.
5. Start CX-Drive.
• Start CX-Drive.
• Select File New and select Drive Type = "Servo" and
"SGDE.
• Then select Drive Type Settings
(cont’d)
Procedure Descriptions
ON
OFF
1234
4
3
2
1
0
F
E
D
C
B
A
9
8
7
6
5
SW1 SW2
(Factory setting: 41)
TOEP_C710806_03A_1_0.book Seite 114 Montag, 2. Juli 2007 3:55 15