116
6. Perform the trial operation.
Check the following during trial operation.
• Are cables correctly connected?
• Servomotor rotation direction
• Servomotor speed
• Motor axis home position (Used when alignment with
the machine is required.)
• Click on connect button to go online with the
Junma.
• Select “Test Run” from the tuning category in the Tree
view pane
• A warning message will be displayed by default
• The Test Run View will appear
• This view allows you to set Servo Mode On and
choose between 3 possible run operations:
(cont’d)
Procedure Descriptions
TOEP_C710806_03A_1_0.book Seite 116 Montag, 2. Juli 2007 3:55 15
To Next Page
Loading...
