4.2 Main Commands
88
3 − STATUS • This command is for maintenance. Parameter initialization can be done.
• Use as SUBCODE = 01H.
• Refer to the next page, for the way to use set this command.
• A command warning will occur and the command will be ignored in the
following cases.
-If parameters are changed mid-operation with CX-Drive: Command
warning 1 (A.95A)
-If CADDRESS is out of the range: Parameter setting warning (A.94A)
-If CSIZE does not match: Parameter setting warning (A.94D)
-If CCMD or CDATA is out of the range: Parameter setting warning
(A.94B)
4
5CCMD CANS
6
7CAD-
DRESS
CAD-
DRESS
8
9 CSIZE CSIZE/
ERRCODE
10
11 CDATA CDATA
12
13
14
15
16 WDT RWDT
Byte ADJ Description
Command Response
TOEP_C710806_03A_1_0.book Seite 88 Montag, 2. Juli 2007 3:55 15
To Next Page
Loading...
