Omron STC-MBE132POE

No.19S185-01
60/68
STC-MBE132POE / STC-MCE132POE
Product Specifications and User’s Guide
11.5 LUTControl
Name Description
LUTSelector Selects which LUT to control.
LUTEnable [LUTSelector] Activates the selected LUT.
LUTIndex [LUTSelector] Control the index (offset) of the coefficient to access in the selected
LUT.
LUTValue [LUTSelector] [LUTIndex] Returns the Value at entry LUT Index of the LUT selected by LUT
Selector.
LUTValueAll [LUTSelector] Accesses all the LUT coefficients in a single access without using
individual LUT Index.
PixelCorrectionAllEnabled Enable pixel correction for all pixels.
PixelCorrectionIndex Determine index of targeted pixel for pixel correction.
PixelCorrectionEnabled
[PixelCorrectionIndex]
Determine if targeted pixel is enabled for pixel correction.
PixelCorrectionX [PixelCorrectionIndex] Determine x-coordinate of targeted pixel for pixel correction.
PixelCorrectionY [PixelCorrectionIndex] Determine y-coordinate of targeted pixel for pixel correction.
11.6 DigitalIOControl
Name Description
LineSelector Selects the physical line (or pin) of the external device connector or the
virtual line of the Transport Layer to configure.
LineMode [LineSelector] Controls if the physical Line is used to Input or Output a signal.
LineFormat [LineSelector] Controls the current electrical format of the selected physical input or
output Line.
LineSource [LineSelector] Selects which internal acquisition or I/O source signal to output on the
selected Line.
LineInverter [LineSelector] Controls the inversion of the signal of the selected input or output Line.
LineDebounceTime [LineSelector] Sets the value of the input line debouncer time.
LineStatus [LineSelector] Returns the current status of the selected input or output Line.
LineStatusAll Returns the current status of all available Line signals at time of polling
in a single bitfield.
UseOutputSelector Selects which bit of the User Output register will be set by User Output
Value.
UseOutputValue [UseOutputSelector] Sets the value of the bit selected by User Output Selector.