(
4-2-3 Setting Constants
The 3G3EV (Standard Model) allows the user to set 18 different constants.
The constants for basic operations are allocated to dedicated indicators,
so the user need not refer to the constant nos. The constants allocated to
dedicated indicators can be also set by lighting the PRGM indicator.
Notethat the operation methods using dedicated indicatorsand the PRGM
indicator are different.
Setting Constants
Setting Constants Using a Dedicated Indicator
Example:
Changing acceleration time from 10 seconds to 50 seconds.
Key
operation
Indicator Example of
data display
Explanation
Press the Mode Key until the ACC indicator lights
up.
Flashing
Press the Increment Key. The data display section
flashes (indicating that the data is yet to be
registered).
Flashing
Press the Increment Key until “50.0” appears in
the data display section. Holding down the key
changes data quickly.
Press the Enter Key to complete the setting
procedure.
Flashing
Note
If the new data is not to be registered, press the Mode Key instead of the Enter
Key. The new data becomes invalid and the next item is displayed.
Chapter 4
To Next Page
Loading...
