Stop Mode Selection
Setting range 0, 1 Factory setting 0
This constant is used to select the stop mode tobe invoked when the STOP/RESETkey
is pressed or when bit 0 of Unit n + 1 (run command) is set to 0.
Value Description
0 Deceleration stop
1 Free running
Forward/Reverse Rotation Selection
Setting range , Factory setting
(forward rota-
tion)
Value Description
Forward rotation
Reverse rotation
Note 1. While the Inverter is being operated with the Digital Operator, the direction of
motor rotation can be changed by lighting the F/R indicator with the Mode Key
first, pressing the Increment or Decrement Key to change the setting, then
pressing the Enter Key.
Note 2. The direction (forward/reverse) of motor rotation depends on the motor model
used. Refer to the instruction manual for the motor.
Chapter 4
To Next Page
Loading...
