'
Wiring Method
•The wiring method is the same as for sequence input/output terminals, described pre-
viously.
•Always separate the transmission cables from the main circuit cables and other power
cables.
•Always connect the positive terminal to the positive terminal and the negative terminal
to the negative terminal.
•Wire the Remote I/O Master Unit (RM201) on the SYSMAC side first, then continue
wiring in order. Set the last Slave Unit (device) as a terminator.
•The overall cable length must be 200 m or less.
•Always separate the transmission line from the main circuit cables and other power
cables. In particular, the transmission line must not be parallel to or close to the output
cables from the Inverter.
Chapter 3
To Next Page
Loading...
