9-12
Pa-
rame-
ter
No.
Refer-
ence
page
Changes
during
opera-
tion
Default
setting
Unit
of set-
ting
Set-
ting
range
DescriptionName
n78 Error log Used to display the latest error recorded.
Display
Note “–
– –” will be displayed if
no error has
been recorded.
Note This parameter is monitored only.
--- --- --- --- 6-23
n79 Software number Used to display the software number of the
Inverter for OMRON’s control reference
use.
Note This parameter is monitored only.
--- --- --- --- ---
Note Values
will be
set in 0.1-Hz increments if the frequency is less than 100 Hz and
1-Hz increments if the frequency is 100 Hz or over.
List of Parameters Chapter
9
To Next Page
Loading...
