2-32
2-2-6 Conforming to EC Directive
The following description provides the wiring method of the Inverter to
meet
DC Directive requirements. If the following requirements
are not sa
-
tisfied, the whole equipment incorporating the Inverter will need further
confirmation.
H Standard Connection
D Main Circuit Terminals
Line breakers
3-phase 200 VAC or
single-phase 200 VAC
Noise Filter
Clamp core
D Control Circuit Terminals
Forward/Stop
Multi-function input 1 (S2)
Multi-function input 2 (S3)
Multi-function input 3 (S4)
Multi-function input 4 (S5)
Sequence
input common
Frequency reference power
supply at +12 V
FREQ
adjuster
Frequency reference input
Frequency reference common
Multi-function
contact output
NO
NC
Common
Analog-monitor output
Analog monitor output common
Note I/O signals can be connected to a single shielded cable.
Design Chapter
2
To Next Page
Loading...
