Omron SYSDRIVE 3G3JV Series

5-17
5-7 Selecting the Reverse Rotation-prohibit
This parameter is used to specify whether to enable or disable the reverse
rotation command sent to the Inverter from the control circuit terminals or
Digital Operator .
The
parameter should be set to “not accept” when the Inverter is applied to
systems that prohibit the reverse rotation of the Inverter.
H Selecting the Reverse Rotation-prohibit (n05)
n05 Reverse Rotation-prohibit Selection Changes during
operation
No
Setting
range
0, 1 Unit of
setting
1 Default setting 0
Set Values
Value Description
0 Accept
1 Not accept
Basic Operation Chapter 5