21
ZN
System Manual
Section 2 UPGRADING THE SYSTEM
Section 2
Setup Methods Suited to Specific Applications
Selecting the feedback method
4. Display [FBTYP] on the main display.
Set the feedback method.
5. Display [RAPID] on the sub-display.
6. Press the ENT key.
This sets the rapid feedback method.
Setting the target cleanliness
7. Display [CLASS] on the main display.
8. Select the target cleanliness class.
9. Press the ENT key.
This sets the specified target value.
Setting the low power air volume level
10. Display [LWIND] on the main display.
11. Set the low power air volume level of
the Air Clean Unit.
Set the air volume level for when the target
cleanliness is satisfied.
12. Press the ENT key.
This sets the specified air volume level.
2sysup.fm21ページ２００７年６月２８日 木曜日 午前９時１７分
To Next Page
Loading...
Need help?
General
