Status attributes Crocus CNV
100 Reference manual
crocusIfConv<2m/Nx64><Tt/Cv>/messages
This table displays informative and error messages, e.g. Reconfigured, Cold Boot, … The messages table
displays maximum 20 messages.
If you do not open a TMA session over the control port, then the messages are also sent to the control
port. This means that if you open a terminal emulation session on the control port, you can monitor these
messages. If you hit the ENTER key, the messages stop.
crocusIfConv<2m/Nx64><Tt/Cv>/deviceId
This displays a unique code. This code is programmed into the Crocus CNV before it leaves the factory.
You can use this code for inventory purposes.
crocusIfConv<2m/Nx64><Tt/Cv>/configurationSaving
This attribute indicates when the Crocus CNV is writing its (new) configuration to the flash memory.
Value Description
busy
The Crocus CNV is busy writing its configuration to the flash memory. During this state, do
not power-down or reboot the Crocus CNV else the new configuration will be lost.
done
The Crocus CNV has finished writing its configuration to the flash memory.
To Next Page
Loading...