OneAccess Crocus CNV - Operating system status attributes

Crocus CNV Status attributes
Reference manual 101
7.3 G703 onboard status attributes
crocusIfConv<2m/Nx64><Tt/Cv>/g703OnBoard/testType
This attribute displays which interface test is currently active on the onboard G703 interface. The possible
indications are:
Value Description
no
No test is active.
al
An Analogue Loop is active.
dl
A Digital Loop is active.
rdl
A Remote Digital Loop is active.
et
An Error Test is active.
alEt
A combination of an Analogue Loop and an Error Test is active.
rdlEt
A combination of a Remote Digital Loop and an Error Test is active.
For more information on these tests, refer to Chapter 11.5 - Diagnostic tests.
crocusIfConv<2m/Nx64><Tt/Cv>/g703OnBoard/testOriginator
This attribute displays the origin of the active test. The possible indications are:
Value Description
nms
The test is initiated by the Total Maintenance Application or a central management
system (e.g. TMA under HP OpenView
®
).
keyboard
The test is initiated by means of the buttons on the front panel of the Crocus CNV.
interface
The test is initiated by the application, via the interface.
remote
The test is initiated by the remote Crocus CNV.
unknown
There are two possibilities:
• No test is running.
• For some reason it is not possible to define the origin of the test.