OneAccess Crocus CNV - Interface Alarms

Alarm attributes Crocus CNV
132 Reference manual
9.5 Interface alarms
Refer to Section 9.2 Introducing the alarm attributes. for the general alarm attributes.
crocusIfConv<2m/Nx64><Tt/Cv>/<dteInterface>/alarmInfo
The different alarms related to the <dteInterface> object together with their explanation and their default
alarmMask and alarmLevel value are given in the following table:
Default value The alarm … is generated …
alarmMask alarmLevel
linkDown
(for RS530, V35,
V36I)
when no RTS signal is detected. I.e. the connection
between the Crocus CNV and the DTE is down.
The linkDown alarm is only generated if the attribute
rtsControl is set to external. If the attribute rtsControl is
set to internal, the linkDown alarm will never be
generated.
enabled 3
linkDown
(for X21)
when no valid C signal is detected. I.e. the
connection between the Crocus CNV and the DTE
is down.
enabled 3
linkDown
(for Bridge)
when there is no connection with the LAN. I.e. the
LAN is not connected or no valid LAN signals are
present.
enabled 3
linkDown
(for Router)
when there is no connection between the router
and the Crocus CNV. Because this connection is
made by the interface connector, it is highly unlikely
that this alarm will be generated. However, when it
does occur it might indicate that the router interface
is faulty.
enabled 3