Crocus CNV Installing and connecting the Crocus CNV
User manual 15
2.5.2 Connecting the power supply
The following table explains how to connect the power supply. The Crocus CNV TT exists in two different
models:
TT model Connector type Connecting the power supply
230/115 Vac standard IEC
power supply
connector
For a 230/115 Vac model, connect the standard IEC power
supply connector to the power inlet. Refer to Section 2.5.1
Table Top connections.
-48 Vdc or 48 Vac 48 V power supply
connector
For a 48 V model, a power supply connector is delivered
with the Crocus CNV:
• For a –48 Vdc connection, the + and - indications are
with respect to each other, not to ground level. This
means that for a standard -48 Vdc connection, the
ground has to be connected to +, while the negative
voltage has to be connected to the -.
• For a 48 Vac connection, the power supply has to be
attached to the connectors indicated with ~.
When the 48 V power supply connector is wired, connect it
to the power inlet. Refer to Section 2.5.1 Table Top
connections.
To Next Page
Loading...