PULSAR
2
ESP
Installation and Operating Manual
OPTIKON 2000
Cod. 111007EN Rev.E
3-2
• Use of accessories and cables other than those provided with the unit may
result in an increase of the emissions or in decreased immunity of the system.
Portable and mobile communications equipment can affect the performance
of the unit.
• Carefully follow the instructions when installing and using the unit , in order
to prevent harmful interferences with other devices in the vicinity. If the
unit causes harmful interferences to other devices (determined by turning
the unit off and on), the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the other devices.
•
Increase the distance between the equipment.
•
Connect the unit into an outlet on a circuit different from that to which the
other devices are connected.
•
Consult your local distributor or OPTIKON 2000 technical assistance
Environmental
• The system should never be used in the presence of flammable anaesthetics,
disinfecting agents, cleaning agents, etc., due to possible fires or explosion.
• The use of flammable anaesthetics (N
2
0), (0
2
), should be avoided unless they
are removed by a gas aspiration system.
• For operating safety do not install the system in a location where it will be
exposed to heating equipment or radiators, direct sunlight, or any other
source of extremely high temperatures.
• Do not install the PULSAR
2
system in such a way that the ventilating openings
are blocked.
• Dispose waste collection fluids according to the local laws/regulations on
disposal of organic materials.
• Do not dispose of PULSAR
2
as unsorted municipal waste. Collect it separately
according to the local laws/regulations on disposal of waste electrical and
electronic equipment.
Electrical
• To reduce the risk of electric shock, do not remove cover. Refer servicing to
qualified service personnel.
To Next Page
Loading...
