OPTIKON PULSAR2 ESP - Vitrectomy

PULSAR
2
ESP Installation and Operating Manual
OPTIKON 2000
Cod. 111007EN Rev.E
8-15
8.4 VITRECTOMY
User Interface
• Parameter windows
available
- Irrigation
- Aspiration
- Cutter
• Irrigation
parameters
- Status
(ON/OFF)
- I.V. Pole height
• Aspiration
parameters
- Status (Venturi
or Peristaltic)
- Vacuum mmHg
(5 – 500)
- Flow rate
cc/min (2-50,
peristaltic
mode only)
- Rise Time
(slow/medium/f
ast)
- Mode
(linear/panel)
• Cutter Parameters
- Cut rate
cuts/min (60-
2500)
- Mode
(linear/panel)
- Tip port
(open/closed)
- Cut type
(multiple/single
)
Operation
Touching the VIT function key, VIT Memory1 screen (VIT1) will be displayed. In
order to display VIT Memory2 screen (VIT2), touch the same key once again (toggle