PULSAR
2
ESP
Installation and Operating Manual
OPTIKON 2000
Cod. 111007EN Rev.E
4-1
4 SYMBOLS
Table shown below reports some symbols approved by I.E.C. and their meaning.
When there is not enough room, they are frequently used on medical equipment to
enable an easy and fast communication of information and warnings. Sometimes
two or more symbols may be assembled to obtain a special meaning.
These symbols are used in the PULSAR
2
label. Before starting to use the unit, you
should familiarize yourself with them and their definitions shown in the table.
SYMBOLS PUBLISHED BY THE
IEC
SYMBOL
DESCRIPTION
ALTERNATING CURRENT
DIRECT CURRENT
PROTECTIVE EARTH (GROUND)
ATTENTION, CONSULT
ACCOMPAINING DOCUMENTS
OFF (POWER: DISCONNECTION
FROM THE MAINS)
ON (POWER: CONNECTION TO
THE MAINS)
TYPE B
PART APPLIED TO THE PATIENT
(BODY)
TYPE BF
FLOATING PART APPLIED TO THE
PATIENT (BODY-FLOATING)
SEPARATE COLLECTION OF
WASTE ELECTRICAL/ELECTRONIC
EQUIPMENT
A
RF EMISSION
To Next Page
Loading...
