Oracle SPARC User Manual

Specify Parallel Boot of the SP and Host
-> set /SP/policy HOST_POWER_ON_DELAY=value
where value can be:
■
enabled – Causes the server to wait for a short time before powering on automatically.
■
disabled – (Default) Server powers on automatically without a delay.
Related Information
■
“Specify the Host Power State at Restart” on page 59
Specify Parallel Boot of the SP and Host
The /SP/policy PARALLEL_BOOT property enables the host to boot and power on in
parallel with the SP. When enabled, parallel booting occurs if an auto-power policy
(HOST_AUTO_POWER_ON or HOST_LAST_POWER_STATE) was on or if a user presses the power
button while the SP is in the process of booting. Oracle ILOM must be running in order to
enable the host to power on in these situations. When this property is set to disabled, the SP
boots first, then the host boots.
Note - Parallel boot is not supported on server modules.
At the Oracle ILOM prompt, type:
-> set /SP/policy PARALLEL_BOOT=value
where value can be:
■
enabled – SP and host boot concurrently.
■
disabled – SP and host boot serially.
Related Information
■
“Power On the Server (Oracle ILOM Web Interface)” on page 25
■
“Power On the Server (Oracle ILOM CLI)” on page 24
■
“Power Off the Server (Oracle ILOM Web Interface)” on page 26
■
“Power Off the Server (Oracle ILOM CLI)” on page 24
60 SPARC and Netra SPARC T5 Series Servers Administration Guide • August 2016

Oracle SPARC Specifications

General

Operating System	Oracle Solaris
Virtualization	Oracle VM Server for SPARC
Processor	SPARC
Threads per Core	8
Memory Type	DDR4
Storage	SAS, SATA
Security Features	Cryptographic Acceleration