Oracle storagetek sl150 Reference Manual

Mode Sense (6)
Julyl 2017 Command Set 113
RHA
Require Hard Address. If the library is not attached to an arbitrated loop, it
shall ignore the RHA bit.
0 = The target follows the normal initialization procedure, including the
possibility of obtaining a soft address during the loop initialization process.
1 = The target attached to an arbitrated loop shall only attempt to obtain its
hard address. If there is a conflict for the hard address selection during loop
initialization or the target does not have a valid hard address available, the
target shall enter the nonparticipating state.
ALWI
Allow Login Without Loop Initialization. If the library is not attached to an
arbitrated loop, it shall ignore the ALWI bit.
0 = The target shall perform the normal loop initialization procedure before
entering the monitoring mode and accepting a login ELS.
1 = The target attached to an FC-AL-2 loop shall use the hard address
available in the connector or in device address jumpers, enter the
monitoring state in participating mode, and accept logins without using the
loop initialization procedure (see FC-AL-2).
DTIPE
Disabled Target Initiated Port Enabled. If the library is not attached to an
arbitrated loop, it shall ignore the DTIPE bit.
0 = The target shall enable itself onto the loop in according to the rules
specified in FC-AL-2.
1 = The target attached to an arbitrated loop shall wait for an initiator to
send the Loop Port Enable (LPE) primitive sequence before inserting itself
into a loop (see FC-AL-2)
DTOLI
Disable Target Originated Loop Initialization. If the library is not attached
to an arbitrated loop, it shall ignore the DTOLI bit.
0 = The target attached by an arbitrated loop shall generate LIP(F7,xx) after
it enables a port into a loop.
1 = The target attached by an arbitrated loop shall not generate a LIP
following insertion into the loop.
RR_TOV units
Resource Recovery Time Out Value Units will always be:
011b = 0.1 second units
RR_TOV
Resource Recovery Time Out Value will always be:
F0h = 24 seconds

Oracle storagetek sl150 Specifications

General

Brand	Oracle
Model	storagetek sl150
Category	Storage
Language	English