Oriental motor BLH Series - Page 29

29
Operation
7.2.3 Selecting the setting method
Setting methods of each operation data number are as follows. (Factory setting)
The setting method can be changed using the
MEXE02
. The changed items will be updated when the motor stops.
Operation data No.
Rotation speed setting
method
Torque limiting value setting
method
Acceleration time
setting method
Deceleration time
setting method
0
External analog setting device
/PWM signal input
Digital VR2 VR2
1 VR1 Digital VR2 VR2
2 Digital Digital Digital Digital
3 Digital Digital Digital Digital
4 Digital Digital Digital Digital
5 Digital Digital Digital Digital
6 Digital Digital Digital Digital
7 Digital Digital Digital Digital
Setting range
Digital
VR1
VR2
External analog setting device
/PWM signal input
Digital
VR1
VR2
External analog setting device
/PWM signal input
Digital setting
VR1
VR2
Digital setting
VR1
VR2
•
The same setting method other than the digital setting cannot be assigned to the rotation speed setting method and
the torque limiting value setting method in the same operation data number.
<Example>
Operation data
No.
Rotation speed
setting method
Torque limiting value
setting method
Acceleration
time setting
method
Deceleration
time setting
method
As shown in the example
left, the same setting
method cannot be
assigned to the same
operation data number.
0
External analog
setting device
/PWM signal input
External analog
setting device
/PWM signal input
VR2 VR2
If the same setting method was assigned, the operation data setting error information is generated.
If the operation data number that is the cause of the operation data setting error information is tried to operate, the
operation prohibited information will be generated.